|
Author
|
Topic: 81 Bronco ???
|
67stang
Gearhead Posts: 753
From:
Registered: Jun 99
|
posted 07-19-2001 10:30 PM
   
As long as I have access to it (its going bye bye soon), I have a question about it.Will the steering knuckles from a 81 Bronco (with the TTB) fit on a 79 Bronco (solid axle)? If so I want to strip the knuckles off this bronco too. Anybody know for sure?
IP: Logged |
MLariviere
Moderator Posts: 1891
From: Biddeford,Me.USA
Registered: May 99
|
posted 07-18-2001 09:23 PM
They probably aren't,because the knuckle points to the back for the steering box on a 79 with a long drag link,while 80-up have the steering box in front,with an inverted Y steering linkage. The hub and spindle are probably interchangable though.[This message has been edited by MLariviere (edited 07-18-2001).]
IP: Logged |
67stang
Gearhead Posts: 753
From:
Registered: Jun 99
|
posted 07-19-2001 10:21 PM
Unless I am mistaken, the knuckle points to the front on the 79 too.
IP: Logged |
MLariviere
Moderator Posts: 1891
From: Biddeford,Me.USA
Registered: May 99
|
posted 07-20-2001 08:42 PM
The box is in the front?  I know the 79 2WD's are in back,and I ASSUMED the 4x4's were too.
IP: Logged |
67stang
Gearhead Posts: 753
From:
Registered: Jun 99
|
posted 07-20-2001 10:56 PM
Now I am going to have to check when I get home, but I could swear that it is. The centerlink goes in front of the diff cover.......
IP: Logged |
67stang
Gearhead Posts: 753
From:
Registered: Jun 99
|
posted 07-31-2001 11:54 PM
OK Mike, the knuckle points forward on the 79. I double checked 
IP: Logged |
MLariviere
Moderator Posts: 1891
From: Biddeford,Me.USA
Registered: May 99
|
posted 08-01-2001 09:51 PM
Where does the steering box go on the 79?
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
