|
Author
|
Topic: Anyone want to measure "A" pillars for me?
|
65coupei6
Gearhead Posts: 283
From: S.F., CA
Registered: May 2000
|
posted 07-22-2001 02:58 PM
   
If anyone has a tape measure handy could you measure you front pillars for me. I have a 65 Mustang and am thinking of getting a Autogage guage pod. But they only make them for the 79-93 Mustang. With a dremel I am sure I could get it to fit.
Thanks in advance!
IP: Logged |
Stewart
Moderator Posts: 6327
From: Monterey, CA Mustangsandmore Member #437
Registered: Apr 2000
|
posted 07-22-2001 04:48 PM
Marco, I'm not sure exactly where the measurments should be made from, but on my 1990 GT, from the prolongation of the dash (the imaginary line created by the dash if you were to continue it across and intersect it with the pillar) up to the top of the windshield, the measurment is 21.25 inches.From the base of the pillar, just below the dash, to the same point at the top, the measurement is 23.75 inches. I Hope that helps. Stewart [This message has been edited by Stewart (edited 07-22-2001).]
IP: Logged |
65coupei6
Gearhead Posts: 283
From: S.F., CA
Registered: May 2000
|
posted 07-22-2001 05:14 PM
Ooops, I should have mentioned I need width not lenght. My fault. But thanks for quick reply.
IP: Logged |
Stewart
Moderator Posts: 6327
From: Monterey, CA Mustangsandmore Member #437
Registered: Apr 2000
|
posted 07-22-2001 05:46 PM
LOL...no prob. BRB
IP: Logged |
Stewart
Moderator Posts: 6327
From: Monterey, CA Mustangsandmore Member #437
Registered: Apr 2000
|
posted 07-22-2001 05:51 PM
Two and one half inches. 2.5 2 1/2 Two & a half I hate not having that fraction on the keyboard. I think there's a code I can type that will do it for me though. Anyway, I hope it'll work for you, Marco. Stewart
IP: Logged |
65coupei6
Gearhead Posts: 283
From: S.F., CA
Registered: May 2000
|
posted 07-22-2001 08:11 PM
thanks again for the measurement!!
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
