|
Author
|
Topic: How do i install a new Tail light Panel
|
MustangRdr68
Gearhead Posts: 385
From: Bensalem, PA
Registered: Jul 2001
|
posted 12-02-2002 09:56 AM
   
What are the steps i need to take, and is there any other way i could put it in temporarily without welding it?Thx Mike ------------------
1968 Mustang Coupe 302 Check out pics of my car here: http://www.geocities.com/mustangrestore
IP: Logged |
SteveLaRiviere
Administrator Posts: 33988
From: Saco, Maine
Registered: May 99
|
posted 12-02-2002 01:34 PM
Here you go:https://mustangsandmore.com/ubb/Forum1/HTML/005477.html Spot welding is the right way to do it. ------------------
'70 Mustang Mach 1 - '72 Mustang Sprint - '94 F-150 Be sure to remember our sponsors, Mustangs Plus, NPD, and Osborn Reproductions.
IP: Logged |
MustangRdr68
Gearhead Posts: 385
From: Bensalem, PA
Registered: Jul 2001
|
posted 12-02-2002 07:43 PM
Is there so kind of diagram that will show me where the spot welds should be ? Thx
------------------
1968 Mustang Coupe 302 Check out pics of my car here: http://www.geocities.com/mustangrestore
IP: Logged |
SteveLaRiviere
Administrator Posts: 33988
From: Saco, Maine
Registered: May 99
|
posted 12-02-2002 07:46 PM
The Osborn body assembly manual has them marked off, but you can't miss them just looking at the panel.------------------
'70 Mustang Mach 1 - '72 Mustang Sprint - '94 F-150 Be sure to remember our sponsors, Mustangs Plus, NPD, and Osborn Reproductions.
IP: Logged |
70grande
Journeyman Posts: 80
From: Renton, Washington
Registered: Mar 2001
|
posted 12-03-2002 04:54 PM
Check out the December issue of Mustang Monthly. It was very helpful when I replaced mine.------------------
1970 Grande 3.50 9",4 wheel disc, gt40-cobra rims(soon) 351W, Calypso Coral, Severe state of restomod
IP: Logged |
bill haab
Gearhead Posts: 143
From: south bend in.
Registered: Oct 2002
|
posted 12-05-2002 04:51 PM
quote:
Originally posted by MustangRdr68:
What are the steps i need to take, and is there any other way i could put it in temporarily without welding it?Thx Mike
IP: Logged |
bill haab
Gearhead Posts: 143
From: south bend in.
Registered: Oct 2002
|
posted 12-05-2002 04:54 PM
There is alot of goog stuff on this site that will help you www.quarterbore.com/mustang
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
