Brought to you in part by:

.

Tools & Supplies by Eastwood

  Mustangsandmore Forums
  '64 1/2 to '73 -- The Classic Mustang
  Jack Stands

Post New Topic  Post A Reply
profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone! next newest topic | next oldest topic
Author Topic:   Jack Stands
Doyle
Journeyman

Posts: 22
From: Annapolis, Maryland
Registered: Oct 2000

posted 10-28-2001 08:14 PM     Click Here to See the Profile for Doyle   Click Here to Email Doyle     Edit/Delete Message   Reply w/Quote

I plan on putting my 70 Bos on jack stands
while I do some work over the winter.
Any recommendations on the placement of
the stands?

IP: Logged

Dave Witthoeft
Gearhead

Posts: 1008
From: IL.
Registered: Dec 2000

posted 10-29-2001 05:18 AM     Click Here to See the Profile for Dave Witthoeft   Click Here to Email Dave Witthoeft     Edit/Delete Message   Reply w/Quote
Depends on what kind of work your going to do. I like to put mine under the rear end and up under the torqe boxes by the frame.

------------------
MCA# 48755
71 Mach 1
69 Fastback
92 F-150
M&M#884

IP: Logged

Gary
Gearhead

Posts: 535
From: Sarasota, Fla. USA
Registered: Jun 99

posted 10-29-2001 05:27 AM     Click Here to See the Profile for Gary   Click Here to Email Gary     Edit/Delete Message   Reply w/Quote
Ditto

IP: Logged

sigtauenus
Gearhead

Posts: 1320
From: Homeless, in transit
Registered: Jun 2000

posted 10-29-2001 02:30 PM     Click Here to See the Profile for sigtauenus   Click Here to Email sigtauenus     Edit/Delete Message   Reply w/Quote
Ditto here too

IP: Logged

Doyle
Journeyman

Posts: 22
From: Annapolis, Maryland
Registered: Oct 2000

posted 10-29-2001 04:31 PM     Click Here to See the Profile for Doyle   Click Here to Email Doyle     Edit/Delete Message   Reply w/Quote

My plan is to remove the gas tank detail
the trunk by removing the undercoating
and repairing the surface rust.
If that goes well - I would like to
do the same on the rear half of the car.

I am very fortunate in that I see no rust
holes but rather lots of surface rust.

I also want to remove the trans and have
it serviced.

IP: Logged

All times are ET (US)

next newest topic | next oldest topic

Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply
Hop to:

Contact Us | Mustangsandmore Front Page

Copyright 2001, Steve LaRiviere


Ultimate Bulletin Board 5.47d

Amazon Honor System Click Here to Pay Learn More

[About M&M][Acronym Guide][Calendar of Events][Chat Room][Classified Ads] [Links]

[Members' Photos] [Restoration Info][Tech Tips] [ Technical Articles][Ford Technical Data

[ Mustangsandmore.com Bookstore] [Advertise on Mustangsandmore.com] [Mustangsandmore.com T-Shirts]