|
Author
|
Topic: Bronco Tilt Wheel Swap Into F150 - 1979
|
skips69
Gearhead Posts: 120
From: Catlin, IL USA
Registered: Mar 2001
|
posted 05-25-2002 07:56 PM
   
I have a 1979 F150 4x4 with standard non-tilt wheel. I have access to a 1979 Bronco 4x4 with a tilt wheel. All appears to be the same or very similiar, but my only concern would be that the Bronco has cruise control on the steering wheel pad, and my truck does not. Does anyone know if these will swap ok? Do I have to use the harness from my truck or can I use the existing steering wheel wiring harness from the Bronco as is? I just assume the connectors would be different at the bottom. If any thoughts or past experiences with this situation, please drop a note here.Thanks!
IP: Logged |
MLariviere
Moderator Posts: 2383
From: Biddeford,Me.USA
Registered: May 99
|
posted 05-25-2002 09:05 PM
There should be no problem putting in the tilt column. There should be a separate harness for the cc,and you can either leave it unplugged,or switch your truck to cruise!  [This message has been edited by MLariviere (edited 05-25-2002).]
IP: Logged |
skips69
Gearhead Posts: 120
From: Catlin, IL USA
Registered: Mar 2001
|
posted 05-25-2002 10:21 PM
Good point, glad I posted the question, didn't think of that.Thanks!
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
