|
Author
|
Topic: horn spring thing
|
roger
Gearhead Posts: 195
From: ontario, canada
Registered: Aug 2000
|
posted 09-09-2003 04:04 PM
   
When you push the horn ring (62 F'lane) there is a knob/spring thing in a tube that makes contact & your horn sounds.
It actually looks like a brush from a generator, anyway i can;t find this part. I'm thinking that other Ford cars used the same set up, does anyone know where to get this part and/or what other Ford/years may have it.
Roger
IP: Logged |
MLariviere
Moderator Posts: 3984
From: Biddeford,Me.USA
Registered: May 99
|
posted 09-09-2003 10:31 PM
I would look in the same year range cars,like the Falcon or Galaxie/Starliner/Custom.
IP: Logged |
KULTULZ
Gearhead Posts: 783
From: Rockville, MD
Registered: Oct 2002
|
posted 09-10-2003 12:55 AM
The FORD Service Part No. you need is;C2OZ 13A821-A
Horn Brush And Insulator Repair Kit The same brush assembly was used on; 62/64 Fairlane
63 (HDTP and CONV only)/64 Falcon
63/64 Ford
64/66 Bird
65 Mustang (with generator) It shouldn't be that hard to find. -Woody's Fairlane Vendor Site- ------------------
I am looking for information concerning factory performance/aftermarket speed parts (1958/1960) used on the MEL (Mercury-Edsel-Lincoln) (Also Thunderbird 59/60) Engine Series (383-410-430-462) produced from 1958 thru 1968. Also older FORD Special Service Tools -MEL Engine Forum-
IP: Logged |
KULTULZ
Gearhead Posts: 783
From: Rockville, MD
Registered: Oct 2002
|
posted 09-10-2003 06:55 AM
-DEARBORN CLASSICS- has one...
IP: Logged |
roger
Gearhead Posts: 195
From: ontario, canada
Registered: Aug 2000
|
posted 09-10-2003 01:04 PM
Thanks very much.
Now if i can just find a guy to make me a croosmember to bolt up a rack to i'll be a happy camper.
I read an article in an old Custom rodder, this shop built a simple bolt in crossmember & mounted a cavalier rack & pinion steering set up, a couple of Borgeson(spelling) joints and according to them the end result was simply an amazing difference in handling, steering.
The total cost was $450.00 bucks!!
I've actually called the shop in L.A. to see if they have the crossmember measurements to see if its applicalbe to Fairlanes but no answer.
Other than springing for a pre-fabbed big buck rack & pinion system has anyone thought about doing this?
Roger in Toronto
IP: Logged |
KULTULZ
Gearhead Posts: 783
From: Rockville, MD
Registered: Oct 2002
|
posted 09-10-2003 07:19 PM
-Total Control Products Rack Kit--TAURUS Rack Conversion- ------------------
I am looking for information concerning factory performance/aftermarket speed parts (1958/1960) used on the MEL (Mercury-Edsel-Lincoln) (Also Thunderbird 59/60) Engine Series (383-410-430-462) produced from 1958 thru 1968. Also older FORD Special Service Tools -MEL Engine Forum-
IP: Logged |
Mustangsandmore Forums
