Tea'sGrabber
Gearhead Posts: 276
From: Seattle, Wash.
Registered: Feb 2003
|
posted 08-30-2004 11:58 AM
 
I believe Comp Engineering and Southside performace do. I just made mine.... very easy to do and welded them in. Any good chassis shop should be able to fab and weld them in. Just don't let them tell you ya have to channel the floors... that's old school. I just used some left over chrome moly tubing from my roll cage. You can use square or round tubing.. just tuck them up close to the floors and you can't see them... Also if you've got carpey installed.... wet it so it doesn't burn.... good luck!!!! Todd------------------
Todd 71 Mav Grabber All orig 306 cu.in. Cast Iron heads. Carillo Rods.Best et. 10.71 @ 124 thru the mufflers.
http://mustangsandmore.50megs.com/MembersPics/TeasGrabber.html
|
