Toploader info - Mustangsandmore Forums

Brought to you in part by:

.

Mustangsandmore Forums

Small Fords and Mercurys

Toploader info

profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone!

next newest topic | next oldest topic

Author	Topic: Toploader info
cpmaverick Gearhead Posts: 1602 From: Auburn, AL. Registered: Jan 2000	posted 02-09-2000 01:35 AM I finally got my toploader to stop leaking. (I recently installed a Motorsport Clutch and Billet Flywheel). I think what stopped it was putting sealer on the tailshaft bolts. You guys have any other tips on sealing these things up? Also, I installed a diaphram-type 10.5" clutch (like a 5.0L Mustang). So far, so good! ------------------ -Charlie Ping http://www.geocities.com/cping3 IP: Logged
Moneymaker Administrator Posts: 21725 From: Lyons, IL, USA Registered: May 99	posted 02-09-2000 11:59 AM Lots of silicone at every case mating surface. There are only two. Alex ------------------ Alex Denysenko Co-Administrator and Moderator IP: Logged
cpmaverick Gearhead Posts: 1602 From: Auburn, AL. Registered: Jan 2000	posted 02-09-2000 12:19 PM That is what I did this time, used silicone as well as new gaskets. Ford has a nice gasket kit for the toploaders. I'll try to get the part #'s, but it was under $15, included the three gaskets and two seals that the toploader uses. E1ZZ-something IP: Logged

All times are ET (US)	next newest topic \| next oldest topic
Administrative Options: Close Topic \| Archive/Move \| Delete Topic
	Hop to:

Contact Us | Mustangsandmore Front Page

Copyright 2004, Steve LaRiviere. All Rights Reserved.

Ultimate Bulletin Board 5.47d

Amazon Honor System

[Acronyms][Calendar][Chat][Classifieds] [Members' Pics]

[ Mustangsandmore.com Bookstore] [ Smokin' Fords] [Tech Articles]