|
Author
|
Topic: Cold Air Induction
|
wc11moreland
Journeyman Posts: 6
From: selma,AL,usa
Registered: Jun 2003
|
posted 07-07-2003 01:24 PM
   
If I Buy a cold air induction What do i need to install it ? Do you need a Maf sensor or any vaccum lines or anything?
Thanks
IP: Logged |
IIGood
Moderator Posts: 3484
From: Arnold, MD, USA
Registered: Jun 99
|
posted 07-07-2003 05:24 PM
I've heard it's best to get a MAF sensor to match the CAI kit. I believe the Densecharger set up has a full-length kit with a MAF sensor... http://www.densecharger.comIf you get one, be careful going through deep puddles. ------------------
Frank S.----MCA Member 40390
'03 Mustang GT coupe
'99 Mustang coupe
'77 Ghia--"II Good"
IP: Logged |
hotstang
Gearhead Posts: 347
From: Murfreesboro, Tn USA
Registered: Jun 99
|
posted 07-10-2003 02:52 PM
persnoally, I would not waste my $$$ on onw, the imporvements over just a K&N filter are not there. But if you do get one IIGood is right..... the Densecharger is the way to go with it------------------
_ _ _ _____________ _ _ _
Matt Kelty
94GT underdrive pullies, K&N filter, 65MM TB, 24LB injectors, 3.73SVO gears, Pro5.0 shifter, JMS custom chip, Centerforce II clutch, MSD 6AL ingintion, 190 LPH fuel pump, and adjustable FPR.
Next mods, springs, sub frame connectors, rear upper and lower control arms Ford Tough 256,000 miles and counting with no problems
IP: Logged | |
Mustangsandmore Forums
