|
Author
|
Topic: Newbie question on changing front pads?
|
TheLoneRangerXLT
Journeyman Posts: 8
From: Tennessee, USA
Registered: Jul 2001
|
posted 07-20-2001 10:54 AM
  
Hi guys, this is my first post here. Looks like a great board!My daughter has a 95 Stang that I have been trying to change the front pads on. Are there any tricks to breaking the caliper bolt loose? I have already destroyed one T-50 Torx bit on it. Thanks for the help.
IP: Logged |
mustangs68
Moderator Posts: 17504
From: Hampton,Virginia,USA MCA#39406 M&M #12
Registered: May 99
|
posted 07-22-2001 03:29 PM
TheLoneRangerXLT,
Just a welcome to Mustangs And More..
& since I have not revoved the pads on our 95 I'm no help at all  sam
IP: Logged |
GTRocks
Gearhead Posts: 2291
From: Lusby, MD, USA
Registered: Jun 99
|
posted 07-22-2001 05:38 PM
I'm almost hesitant to post this since it seems too obvious. On my '93 the bolt has a torx center, but you can put a socket on the outside. That's how I got it off. I assume the '95's aren't that way?!?!
IP: Logged |
TheLoneRangerXLT
Journeyman Posts: 8
From: Tennessee, USA
Registered: Jul 2001
|
posted 07-23-2001 11:04 AM
Thanks for the welcome, 68.GT, the bolt head is to the inside of the wheel well, and I couldn't see it very well. I will check to see if a socket will go on it. Thanks. [This message has been edited by TheLoneRangerXLT (edited 07-23-2001).]
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
