351 intake manifold - Mustangsandmore Forums

Brought to you in part by:

.

Mustangsandmore Forums

'69 to '73 -- The Musclecar Mustang

351 intake manifold

profile | register | preferences | faq | search

next newest topic | next oldest topic

Author	Topic: 351 intake manifold
ernies big red 4dr Journeyman Posts: 1 From: Hawthorne Calif. USA Registered: Oct 2006	posted 10-14-2006 12:18 PM I need the torque sequence for my 351 cleveland intake manifold. It has a B&M 144 blower,with a aluimium manifold. Iam not sure which heads are on this motor? I think they are 2v? Can I ID them visially? What would some of the differances be? I need the torque sequence and pounds for the manifold and the blower. I dont know the year or the type of car it came from. IP: Logged
68 Coop Gearhead Posts: 5400 From: Mesquite, NV. 89027 Registered: Oct 2004	posted 10-14-2006 01:22 PM I'm pretty sure you snug them all down first, then go in a zig-zag pattern. Check/tighten again after the engine has been ran up to operating temp. ------------------ William M&M# 4256 MCA# 64831 68 Coupe 289 C4 3:55's/Trac-Lok IP: Logged
mach1mike Gearhead Posts: 123 From: UK Registered: Apr 2004	posted 10-14-2006 07:27 PM quote: Originally posted by ernies big red 4dr: . Iam not sure which heads are on this motor? I think they are 2v? Can I ID them visially? What would some of the differances be? Most obvious would be a 2 or a 4 cast into the upper corners of each head IP: Logged

All times are ET (US)	next newest topic \| next oldest topic
Administrative Options: Close Topic \| Archive/Move \| Delete Topic
	Hop to:

Contact Us | Mustangsandmore Front Page

Copyright 2006, Steve LaRiviere. All Rights Reserved.

Ultimate Bulletin Board 5.47d

Amazon Honor System

[Acronyms][Calendar][Chat][Classifieds] [Members' Pics]
[Tech Articles]