|
Author
|
Topic: Timing my 302
|
77 Cobra
Journeyman Posts: 34
From: Bladen,Nebraska
Registered: Jun 2002
|
posted 05-19-2003 04:20 AM
   
Started the Cobra for the first time last Sat.But now I can not set the timing because of everything in the road.Can't see the timing pointer because of the lower radiator hose,power steering pump,and A/C compressor.Also I am showing no oil pressure at all on the new gauge I got.But there is oil pressure.I took the line off the block and oil shot out of the block,plus I have ran the engine well over an hour so if there was no oil pressure I would have serious problems by now.Right now I have the timing set where when the engine is warm,190 degrees it will start by just hitting the starter with out pressing the gas pedal or anything ,am I close?
IP: Logged |
SteveLaRiviere
Administrator Posts: 35449
From: Saco, Maine
Registered: May 99
|
posted 05-19-2003 06:22 PM
You could use the old fashioned 'keep advancing until it pings then back it off a tad.' Very scientific.  ------------------
'70 Mustang Mach 1 - '72 Mustang Sprint - '94 F-150 Please remember our sponsors,
Mustangs Plus, NPD, Osborn Reproductions, MyFordPerformance.com, and FordRamAir.com
IP: Logged | |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
