|
Author
|
Topic: Cam for nitrous 5.0?
|
Tom G
Gearhead Posts: 1069
From: Bethlehem, Pa USA
Registered: Nov 2001
|
posted 07-16-2005 09:59 AM
 
Need a recommendation for a cam to go with 100 shot of N2O on a carbed 5.0 I want low maintenance Hyd roller cam. 5 spd 3.89 gears and drag radials. Already have 1.7 rockers on gt40x heads and block.
Was looking at Summitt and the comp nitrous cam looked like too much cam for me without notching the pistons.------------------
67 Mustang F/B 302 GT-40X FMS engine RPM Air Gap 650 Holley DP Crane 1.7 roller rockers, Edelbrock Performer Nitrous system, Dynomax ceramic coated headers T5, cable clutch Flows X Pipe 3.89 9". Clearwater Aqua GT Clone Vintage wheel works 40 series 16X8 225 front 255/50 rear drag radials 13.25 @ 103mph 88 GT 5 spd 77k original miles Red and Silver
|
steve'66
Gearhead Posts: 9835
From: Sonoma,CA,USA
Registered: Mar 2000
|
posted 07-16-2005 11:16 PM
A N20 cam should have more exhaust than intake, and a wider lsa. The intake is being force fed, but you still need to get rid of the exhaust naturally. Hope that helps,SteveW
| |
