Moneymaker
Administrator Posts: 26242
From: Lyons, IL, USA
Registered: May 99
|
posted 04-23-2005 10:23 AM
Made a simple two piece spring eye affair out of a aluminum bushing and steel tubing.
Bushing was interferance fit into the spring eye, then the equal length of steel tube was loose fit in to the bushing.
Torington bearings and flat washers on the ends. Lots of RP grease and it works very slick.------------------
Alex Denysenko
Co-Administrator and Moderator NHRA/IHRA/SRA member and licensed Superstock driver
NHRA and IHRA SS/LA & SS/MA National Record Holder '00,'01,'02,'03,'04 &'05
First NHRA & IHRA 289 automatic Superstock Mustang in the TENS 06-99
First SS/MA in the TENS 04-03
IHRA division 5 Superstock Champion
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28 The Barry of BarrysGrrl Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
www.moneymakerracing.com
IP: Logged |