|
Author
|
Topic: Fuel Cell and AN fitting questions...
|
steve'66
Gearhead Posts: 9476
From: Sonoma,CA,USA
Registered: Mar 2000
|
posted 04-02-2005 01:22 PM
   
I've had this fuel cell for a few years. It's 17" X 17" X 11", plastic, foam filled, made by HPS in Lakeland Fl in November 1999, Mat'l type CL-7004, FIA Spec FT-3.
How many gallons will it hold? Is it OK for NHRA? It has molded in nuts for mounting, can I use them or should it be strapped down? I plan on putting it in the trunk, what are the rules for that? Where do I vent it? And, the most important question. What size AN male fittings are .390" ID and .730 OD of the threads? What size is .160 ID and .430 OD threads? Thanks guys! SteveW
IP: Logged |
Moneymaker
Administrator Posts: 26811
From: Lyons, IL, USA
Registered: May 99
|
posted 04-02-2005 01:36 PM
Fine for NHRA.
You can use the nuts.
12 gallon capacity.
Large threads are # 8AN and small are #4AN
------------------
Alex Denysenko
Co-Administrator and Moderator
NHRA/IHRA/SRA member and licensed Superstock driver
NHRA and IHRA SS/LA & SS/MA National Record Holder '00,'01,'02,'03,'04 &'05
First SS/MA in the TENS!
IHRA division 5 Superstock Champion
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28 The Barry of BarrysGrrl Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
www.moneymakerracing.com [This message has been edited by Moneymaker (edited 04-02-2005).]
IP: Logged |
I65Stang
Gearhead Posts: 6502
From: Folsom, CA
Registered: Jun 99
|
posted 04-02-2005 01:42 PM
12 gallons, thats that only one I can answer  .
IP: Logged | |
Mustangsandmore Forums
