f100cleveland
Gearhead Posts: 295
From: St. James, MN
Registered: Sep 2004
|
posted 03-14-2005 08:31 PM
I've been having a problem with my exhaust valve guide seals sealing too good. I've heard from a few different shops that I should run an umbrella seal on the exhaust side. Does anyone know if there is an umbrella seal out there to fit in a dual spring with dampner? I believe its like 0.730" or so inside diameter. ------------------
1982 Ford F100 2wd Shortbox. Powered by a 357 Cleveland w/ closed chamber 4v's and a Funnelweb. Full Roller c-6 trans with Gear Vendors Overdrive and 4.86 geared Detroit Locker equipped 9" rear. 1982 F100 351c 4v 1977 F150 460 Burnout Truck
IP: Logged |
Moneymaker
Administrator Posts: 25883
From: Lyons, IL, USA
Registered: May 99
|
posted 03-15-2005 10:36 AM
Several companies offer them.
Take a spring to a larger machine shop or engine rebuilder and they can match one up.------------------
Alex Denysenko
Co-Administrator and Moderator NHRA/IHRA/SRA member and licensed Superstock driver
NHRA and IHRA SS/LA & SS/MA National Record Holder '00,'01,'02,'03,'04 &'05
First SS/MA in the TENS!
IHRA division 5 Superstock Champion
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28 The Barry of BarrysGrrl Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
www.moneymakerracing.com
IP: Logged |