392 stroker - Mustangsandmore Forums

Brought to you in part by:

.

Mustangsandmore Forums

392 stroker

profile | register | preferences | faq | search

next newest topic | next oldest topic

Author	Topic: 392 stroker
jeeeptech Journeyman Posts: 14 From: TR S.C. Registered: Mar 2004	posted 02-10-2005 09:08 PM Can someone recomend a piston for a 392 stoker engine hyper or forged that isnt 600.00 a set I am running stock rods 5.956 crank stroke 3.850 and 63cc aluminum heads I am wanting a compression ratio as close to 9.5:1 Thanks...Russell IP: Logged
TomP Gearhead Posts: 6000 From: Delta BC Canada Registered: Dec 99	posted 02-10-2005 10:10 PM It's just a stock 302 application piston, they should be cheap enough. IP: Logged
N266fords Gearhead Posts: 1652 From: Sierra Vista ,Az USA Registered: Apr 2003	posted 02-11-2005 12:04 PM It will have to be a dish piston to achieve that compression. Mine was 13cc dish I used Je pistons but then again my compression ratio was 10.5/1 that compression ratio a msd unit and alluminum heads should be fine for the street. never got to build mine as my Ex or soon to be Ex has all my stuff Bruce IP: Logged
Bloose Gearhead Posts: 751 From: Milwaukee, WI Registered: Dec 2001	posted 02-11-2005 05:59 PM How about a KB364? 22cc dish compression should work out to be around 9.3:1. I use the KB hyper and spray 125HP to the motor and they seem to have held up fine. They would likely be well under $300. HTH, B-loose IP: Logged
Clark Gearhead Posts: 730 From: Rowlett,Texas Registered: Aug 99	posted 02-12-2005 09:30 PM On my 393W just used a good set of stock dished 302 pistons, just make sure that there skirts will clear the crank throws. But even with those 9.5 will be hard to reach, I am at about 10.5 ------------------ 69 393W Sportsroof Deluxe [This message has been edited by Clark (edited 02-12-2005).] IP: Logged
rdinmv Gearhead Posts: 154 From: orange county CA Registered: Feb 2004	posted 02-12-2005 11:45 PM you could always open up your chambers IP: Logged
jeffstar Gearhead Posts: 123 From: Toronto, Ontario, Canada Registered: Feb 2003	posted 02-13-2005 03:19 PM I used KB-192 IP: Logged
jeeeptech Journeyman Posts: 14 From: TR S.C. Registered: Mar 2004	posted 02-13-2005 05:40 PM the 192 with a stock head gasket and 0.00 deck height will come out to approx 10.5:1 a bit more than I want but thanks for the input it may be an option...I have been looking at the sealed power 272ap the only problem is I cant find the cc for the piston dome... IP: Logged

All times are ET (US)	next newest topic \| next oldest topic
Administrative Options: Close Topic \| Archive/Move \| Delete Topic
	Hop to:

Contact Us | Mustangsandmore Front Page

Copyright 2005, Steve LaRiviere. All Rights Reserved.

Ultimate Bulletin Board 5.47d

Amazon Honor System

[Acronyms][Calendar][Chat][Classifieds] [Members' Pics]

[ Mustangsandmore.com Bookstore] [ Smokin' Fords] [Tech Articles]