|
Author
|
Topic: Rarest 4100 ever?
|
Fastback68
Gearhead Posts: 3332
From: Sucat, Paranaque, Philippines
Registered: Jul 99
|
posted 01-28-2005 08:45 PM
   
Anyone have any knowledge / comments on this?
Alex, I think it was, alerted me to the Holley 4010 - basically a beefed up 4100. Anyone know good cars to pull these off?
So while I was researching, I came across this ...
http://m571.com/yblock/carb.htm
In 1958 only, a 4100 with 1.19 venturis was made, for 650 to 670 cfm.
Is that an all-time great carb? Do I stand a chance in hell of finding one?
Thanks,
Simon
IP: Logged |
Moneymaker
Administrator Posts: 26513
From: Lyons, IL, USA
Registered: May 99
|
posted 01-28-2005 09:39 PM
The 1.19 Autolite 4100 was/is 700 CFM.
It is very rare and a great carb to set up if you can locate one.------------------
Alex Denysenko
Co-Administrator and Moderator NHRA/IHRA/SRA member and licensed Superstock driver
NHRA and IHRA SS/LA & SS/MA National Record Holder '00,'01,'02,'03,'04 &'05
First SS/MA in the TENS!
IHRA division 5 Superstock Champion
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28 The Barry of BarrysGrrl Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
www.moneymakerracing.com
IP: Logged |
rdinmv
Gearhead Posts: 144
From: orange county CA
Registered: Feb 2004
|
posted 01-29-2005 01:56 AM
I think that carb was only made 1 or 2 yrs and was only on a mercury big block I think a 383 or something like that.......good luckFunny I just found an old holley 4011 in my garage it was their copy of the 4100 back in the 80's or early 90's, its a spread bore from an old boat I had with a olds engine. my 67 vert http://htwheelz.smugmug.com
IP: Logged | |
Mustangsandmore Forums
