|
Author
|
Topic: lower control arms
|
1965stangracr
Journeyman Posts: 17
From: Clear Spring , Md.21722 USA
Registered: Jan 2004
|
posted 12-06-2004 10:17 PM
   
Alex or anyone know why you can't take the lower ball joint off of a 65 mustang control arm , I want to powder coat them before I put them back on ------------------
65 mustang bracket racer best et 10.62 124
2001&2002 super stock Runner up Presidents cup Nationals SS/PBA-1 Nat. record Holder 01,02,03,04 9.58 140.99
IP: Logged |
Moneymaker
Administrator Posts: 26513
From: Lyons, IL, USA
Registered: May 99
|
posted 12-06-2004 10:25 PM
Who says you can't?
Are they riveted in?------------------
Alex Denysenko
Co-Administrator and Moderator NHRA/IHRA/SRA member and licensed Superstock driver
MCA member# 53321
NHRA and IHRA SS/LA & SS/MA National Record Holder '00,'01,'02,'03,& '04
First SS/MA in the TENS!
IHRA division 5 Superstock Champion
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28 The Barry of BarrysGrrl Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
www.moneymakerracing.com
IP: Logged |
GregK
Gearhead Posts: 182
From: Clear Spring, Md
Registered: Mar 2004
|
posted 12-07-2004 07:22 AM
Sounds like big Daddy says "just do it" If it works then you can do mine  ------------------
1968 coupe 351W, Bored.030,Stock Crank, Stock Rods,Decked,KB Hyper. flat top pistons. Bullet Cam 231/[email protected]/.541 lift,Stock heads,RPM Air Gap,Holley 670 Street Avenger,MSD Ignition,C4 Trans.,9" rear with 4.11 posi. best time 12.381 @ 105.04 mph in the 1/4
IP: Logged | |
Mustangsandmore Forums
