|
Author
|
Topic: 10L reluctor for a 351 Duraspark
|
jeffstar
Gearhead Posts: 123
From: Toronto, Ontario, Canada
Registered: Feb 2003
|
posted 09-18-2004 09:44 AM
   
Hi The reluctor slots on my 351 style Duraspark are 13 and 18.
The 13 is a bit too wide if I want to run a decent amount of inital timing, so I am looking for a 10L reluctor. Are reluctors from a 302 style Duraspark compatable with the 351? Any suggestions on what vehicle would use the 10L reluctor Thanks in advance
IP: Logged |
steve'66
Gearhead Posts: 9476
From: Sonoma,CA,USA
Registered: Mar 2000
|
posted 09-18-2004 05:56 PM
Why not just shorten up the slot, either with weld or even J-B weld epoxy? Shorten up the advance and run 20 initial and 35-40 total.  SteveW
IP: Logged |
Dubz
Gearhead Posts: 1888
From: Manitoba Canada
Registered: Oct 2002
|
posted 09-18-2004 06:00 PM
quote:
Originally posted by steve'66:
Why not just shorten up the slot, either with weld or even J-B weld epoxy? Shorten up the advance and run 20 initial and 35-40 total. SteveW
is there somewhere that has the listings for what size for what advance?
IP: Logged |
steve'66
Gearhead Posts: 9476
From: Sonoma,CA,USA
Registered: Mar 2000
|
posted 09-18-2004 10:18 PM
It isn't rocket science. If it's 13 degrees and you want it to be 10, then shorten it up by a little less than a 1/4.  Check with a timing light. SteveW
IP: Logged |
Mustangsandmore Forums
