Brought to you in part by:

.

JC Whitney clearance center!
  Mustangsandmore Forums
  Ford Racing
  U Joint dimensions needed

Post New Topic  Post A Reply
profile | register | preferences | faq | search

next newest topic | next oldest topic
Author Topic:   U Joint dimensions needed
Strain Gang
Gearhead

Posts: 212
From: Thor, Iowa
Registered: Mar 2003

posted 07-21-2004 07:00 PM     Click Here to See the Profile for Strain Gang   Click Here to Email Strain Gang     Edit/Delete Message   Reply w/Quote
Anybody know the dimensional differences (if any) between a 1330 and 1350 U joint? Im trying to figure out if I need to buy a new yoke for our 9in. Thanks, Steve.

IP: Logged

SteveLaRiviere
Administrator

Posts: 43152
From: Saco, Maine
Registered: May 99

posted 07-21-2004 07:53 PM     Click Here to See the Profile for SteveLaRiviere   Click Here to Email SteveLaRiviere     Edit/Delete Message   Reply w/Quote
This should help:

"The 1330 and 1350 both measure approximately 3 5/8 wide. The 1310 and 1330 series can have cap diameters of 1 1/16 and/or 1 1/8 inch or a combination of both sizes. The 1350 series has a cap diameter of 1 3/16 inch and the body and journals are bigger than the 1310 or 1330. Remember 1350 is almost never found in production car driveshafts."

http://www.dennysdriveshaft.com/html/faq.html#What is the difference between 1310, 1330 and 1350 Series

------------------
'70 Mustang Mach 1 351C 4V/FMX/3.25 Open
'70 Mustang Convertible 250 I6/3 speed/2.79 Open
'72 Mustang Sprint Hardtop 351C 4V/FMX/4.30 Trac Loc
'94 F-150 XL 5.8L/E4OD/3.55 Limited Slip

IP: Logged

TomP
Gearhead

Posts: 5761
From: Delta BC Canada
Registered: Dec 99

posted 07-22-2004 01:36 AM     Click Here to See the Profile for TomP   Click Here to Email TomP     Edit/Delete Message   Reply w/Quote
Mr Steve sez... "Remember 1350 is almost never found in production car driveshafts"

Ahh sorta... new Mustang Cobras have 1350's in the driveshafts. They are also used on 1 ton pickups and half shafts of some independant rear ends. Most Ford 1330's are 1 1/16" cups where GM's seem to be 1 1/8"

IP: Logged

All times are ET (US)

next newest topic | next oldest topic

Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply
Hop to:

Contact Us | Mustangsandmore Front Page

Copyright 2005, Steve LaRiviere. All Rights Reserved.


Ultimate Bulletin Board 5.47d

Amazon Honor System Click Here to Pay Learn More

[Acronyms][Calendar][Chat][Classifieds] [Members' Pics]

[ Mustangsandmore.com Bookstore] [ Smokin' Fords] [Tech Articles]