|
Author
|
Topic: Chamfering flat tappet lifters?
|
rustang@home
Gearhead Posts: 134
From: Clarion, PA
Registered: Jan 2004
|
posted 05-31-2004 01:40 PM
  
I'm going to be running a big duration (in the 260-270 range at .050"), low lift (.481) cam in my 347. Someone mentioned about chamfering the lifters. Was looking over my stuff this morning, and right on my lifters' box it says something to the affect that chamfering may be required, special machining process.So who's dealt with this type of thing, and who offers this type of service? How would I determine the amount of chamfering I'd need? ------------------
IP: Logged |
Moneymaker
Administrator Posts: 26813
From: Lyons, IL, USA
Registered: May 99
|
posted 05-31-2004 01:54 PM
Sherman Racing Lifters
Cliff Sherman
225-473-4923------------------
Alex Denysenko
Co-Administrator and Moderator NHRA/IHRA/SRA member and licensed Superstock driver
MCA member# 53321
NHRA and IHRA SS/LA & SS/MA National Record Holder '00,'01,'02,'03,& '04
First SS/MA in the TENS!
IHRA division 5 Superstock Champion
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28 The Barry of BarrysGrrl Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
www.moneymakerracing.com
IP: Logged |
Rustang
Gearhead Posts: 805
From: Clarion PA
Registered: Nov 2000
|
posted 06-01-2004 07:13 AM
Thanks Alex, I'll give him a shout 
IP: Logged |
Mustangsandmore Forums
