Brought to you in part by:

.

JC Whitney clearance center!
  Mustangsandmore Forums
  Ford Racing
  Axle Machining?

Post New Topic  Post A Reply
profile | register | preferences | faq | search

next newest topic | next oldest topic
Author Topic:   Axle Machining?
Mooney
Gearhead

Posts: 1691
From: Marietta, Ga
Registered: Oct 2003

posted 04-01-2004 08:26 PM     Click Here to See the Profile for Mooney   Click Here to Email Mooney     Edit/Delete Message   Reply w/Quote
Whats it run to get axles machined? I think I'll only need about 1-2 inches off 'em but was just looking for a ball park figure for when I start calling around to see whether or not I'll be getting a good deal or not.
Thanks!
Luke

IP: Logged

steve'66
Gearhead

Posts: 9104
From: Sonoma,CA,USA
Registered: Mar 2000

posted 04-01-2004 09:23 PM     Click Here to See the Profile for steve'66   Click Here to Email steve'66     Edit/Delete Message   Reply w/Quote
Call Moser,

Two new axles are only $350 or so. I'd guess shortening yours would be less than 100 each.

SteveW

IP: Logged

All times are ET (US)

next newest topic | next oldest topic

Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply
Hop to:

Contact Us | Mustangsandmore Front Page

Copyright 2005, Steve LaRiviere. All Rights Reserved.


Ultimate Bulletin Board 5.47d

Amazon Honor System Click Here to Pay Learn More

[Acronyms][Calendar][Chat][Classifieds] [Members' Pics]

[ Mustangsandmore.com Bookstore] [ Smokin' Fords] [Tech Articles]