|
Author
|
Topic: Holley Blue Rebuild?
|
H8CHEVY
Gearhead Posts: 280
From: Southern Cali
Registered: Jun 2000
|
posted 02-11-2004 09:08 PM
   
The pump just stopped pushing gas on me.. Sounds like its pushing air instead, fuel lines are fine, motor is still spinning. Pulled the lower housing off and have two questions. 1- The shaft which the impellers spin on is slightly off center? I figured this is right? 2- The impellers themselves, are still wide enough to touch the inner wall of the cylinder they sit in on the wider side, yet, still fit bye on the front side. They measure about 3/16" wide x 5/8" long. Worn out??? Any Suggestions? Also, no the pump wasnt leaking. thanks alot. ------------------
"In the wise words I was once told bye Jiggy"
IP: Logged |
Moneymaker
Administrator Posts: 25883
From: Lyons, IL, USA
Registered: May 99
|
posted 02-11-2004 10:30 PM
Rotors and vane sound OK.
Pull out the screw on the side and check the valve and spring.------------------
Alex Denysenko
Co-Administrator and Moderator NHRA/IHRA/SRA member and licensed Superstock driver
MCA member# 53321
NHRA and IHRA SS/LA & SS/MA National Record Holder '00,'01,'02,'03,& '04
First SS/MA in the TENS!
IHRA division 5 Superstock Champion
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28 The Barry of BarrysGrrl Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
www.moneymakerracing.com
IP: Logged |
H8CHEVY
Gearhead Posts: 280
From: Southern Cali
Registered: Jun 2000
|
posted 02-11-2004 10:49 PM
Valve and spring look fine. ------------------
"In the wise words I was once told bye Jiggy"
IP: Logged |
Mustangsandmore Forums
