flowtech - Mustangsandmore Forums

Brought to you in part by:

Mustangsandmore Forums

Ford Racing

flowtech

profile | register | preferences | faq | search

next newest topic | next oldest topic

Author

Topic: flowtech

carnutt331
Journeyman

Posts: 27
From: Toms River N.J.
Registered: Jun 2003

posted 10-11-2003 05:05 PM

Hello
i looked up those flowtech headers that are suppose to be identical to the hooker 6111.flowtech says the tube size on the headers are 1" 1/2 not 1" 5/8 od.could you clear this up i been thinking about purchasing the flowtechs if they are the same size. thank you for your help

IP: Logged

BLstangin
Gearhead

Posts: 817
From: St. James, MN
Registered: Apr 2002

posted 10-12-2003 01:30 AM

The flowtechs are 1 1/2 inches. I have them on my car. They are a nice header for the money though. They also have a nice o-ring type of a seal to the heads and they haven't leaked yet. I am happy with them. Expecially since they are only $85 at Summit for everything with hardware and gaskets.

------------------
1970 coupe restored with the help of my dad. 306 with 600 holley, Weiand Stealth intake, headers, Comp cam, harland sharp roller rockers, kb pistons, 11:1 compression ratio, pertonix ignitor 2 with matched coil, lakewood bellhousing, 4-speed toploader, and 2.79 open 8" rear. Soon to be 9" 3.50 trac-lok
1986 f-150, 5.0, factory towing package with original c-6 trans

IP: Logged

All times are ET (US)	next newest topic \| next oldest topic
Administrative Options: Close Topic \| Archive/Move \| Delete Topic
	Hop to:

Contact Us | Mustangsandmore Front Page

Ultimate Bulletin Board 5.47d

[Acronyms][Calendar][Chat][Classifieds] [Members' Pics]

[ Mustangsandmore.com Bookstore] [ Smokin' Fords] [Tech Articles]