|
Author
|
Topic: stock cam with aftermarket heads?
|
Dubz
Gearhead Posts: 1781
From: Manitoba Canada
Registered: Oct 2002
|
posted 09-03-2003 03:31 AM
   
Would a stock flat tappet work allright with a set of complete rousch 200's?? would the spring pressures be too high or anything------------------
1974 Gran Torino, 351W
rpm air gap intake, Holley 670 carb, 1" 4 hole spacer
My Page [This message has been edited by Dubz (edited 09-03-2003).]
IP: Logged |
mustangboy
Gearhead Posts: 833
From: Ont, Canada
Registered: Mar 2002
|
posted 09-03-2003 01:05 PM
Can't see it being a problem.As far as I know a cam is a cam as far as hardness goes.Obviously the heads will work much better when you get a better cam but it will be interesting to see how much of a difference just the heads alone would make.------------------
1968 mustang j-code sprint.13.69@101 306cu.in, stock ported heads,weiand exellerator,650 holley DP,hedman hedders,comp 292 Magnum cam,4-speed,8 inch 4.11 detroit locker http://mustangsandmore.50megs.com/MembersPics/mustangboy.html
IP: Logged | |
Mustangsandmore Forums
