|
Author
|
Topic: High speed miss
|
Bloose
Gearhead Posts: 692
From: Milwaukee, WI
Registered: Dec 2001
|
posted 08-12-2003 09:24 PM
   
I made calls today to Trick flow, Crane, and MSD to get their takes on my stumble above 5500 rpm. It sounds like valve float is likely not my problem. The springs I have are 110lbs at the seat and 300 at .500 lift. They are supposed to be for Hydralic roller cams so they should work fine with a Hyd FT cam. So MSD was my last call. I talked to him and he said the trigger wires must be seperate from any wires that carry voltage. Mine are run with all the other wires. He said in that case I need to run a shielded cable. He said this is likely my problem. So this week I'll change this over and hope like hell that's the only problem. Wish me luck. B-loose [This message has been edited by Bloose (edited 08-13-2003).]
IP: Logged |
steve'66
Gearhead Posts: 9104
From: Sonoma,CA,USA
Registered: Mar 2000
|
posted 08-12-2003 11:49 PM
Good luck,SteveW
IP: Logged |
SteveLaRiviere
Administrator Posts: 43791
From: Saco, Maine
Registered: May 99
|
posted 08-13-2003 05:34 PM
"High speed miss" would be a good nickname for Melissa.  ------------------
'70 Mustang Mach 1 - '70 Mustang Convertible - '72 Mustang Sprint - '94 F-150 Please remember our sponsors,
Mustangs Plus, NPD, Osborn Reproductions, and FordRamAir.com
IP: Logged |
steve'66
Gearhead Posts: 9104
From: Sonoma,CA,USA
Registered: Mar 2000
|
posted 08-13-2003 06:40 PM
Steve,That's good, I'll try it on her this weekend and see what she thinks. SteveW
IP: Logged |
SteveLaRiviere
Administrator Posts: 43791
From: Saco, Maine
Registered: May 99
|
posted 08-13-2003 06:50 PM
If she doesn't like it, you didn't get it from me...  ------------------
'70 Mustang Mach 1 - '70 Mustang Convertible - '72 Mustang Sprint - '94 F-150 Please remember our sponsors,
Mustangs Plus, NPD, Osborn Reproductions, and FordRamAir.com
IP: Logged |
Mustangsandmore Forums
