|
Author
|
Topic: C6 question Column shift to floor shift trans.
|
68 S-code GT
Gearhead Posts: 2746
From: Sayreville, NJ, US
Registered: Mar 2000
|
posted 08-07-2003 08:06 AM
   
I also had this posted in the classic mustang section but thought I might get more info here. I kind of think Alex said on another post that in order to change a column shift C6 to a floor shift that I would have to swap valve bodies. Are the valve bodies different or is it only the manual shift shaft? If this is the way to do it then I guess on the C6 I would have to do it. If it's only the shift shaft then I might not have to pull the valve body let alone swap it.
IP: Logged |
Moneymaker
Administrator Posts: 26513
From: Lyons, IL, USA
Registered: May 99
|
posted 08-07-2003 09:43 AM
Valve bodies are the same.
The shift levers are different.
The floor shift lever point straight up and the column lever points down.
You have to remove the valve body to replace it.------------------
Alex Denysenko
Co-Administrator and Moderator NHRA/IHRA/SRA member and licensed Superstock driver
MCA member# 53321
NHRA and IHRA SS/LA National Record Holder '00,'01,'02,&'03
First SS/MA in the TENS!
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28
Professional Manwhore
The Barry of BarrysGrrl Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
www.moneymakerracing.com
IP: Logged |
68 S-code GT
Gearhead Posts: 2746
From: Sayreville, NJ, US
Registered: Mar 2000
|
posted 08-07-2003 06:17 PM
Is it the whole assemble or just that stamped steel part that the linkage connects to? quote:
Originally posted by Moneymaker:
Valve bodies are the same.
The shift levers are different.
The floor shift lever point straight up and the column lever points down.
You have to remove the valve body to replace it.
IP: Logged |
Mustangsandmore Forums
