I��m having the block decked. My instructions were to leave No. 1, 4, 5 & 8 pistons in the hole and bring head & intake gaskets. That they would port match the intake and 0-deck the block. I have read here lately that there should be some concern with the oil galley plugs if milling or decking is done.

Since the engine was rebuilt but never started and I decided to tear it back down and have it 0-decked, will there be a problem if the rod bearings get mixed up? Are there any questions I should be asking other than their experience working on Fords?

Thanks

Buck

Sounds like they know what they're doing.