Brought to you in part by:
Topic: People with Cometic Gaskets
From: Macon,Georgia, U.S.A.
Registered: Mar 2002
posted 04-24-2003 11:03 PM
I was wondering who else here had used the COMETIC MLS head gaskets and if you simply installed them dry ,or did you use any sealer on the water ports? The guy at Cometic told me to just lay them on the block and bolt the heads on with NO type of sealer at all ...did you guys do that ,and if so did everything seal OK ? Just curious.
From: Lyons, IL, USA
Registered: May 99
posted 04-24-2003 11:07 PM
I ALWAYS spray them with a thin coat of KW Copper Coat.
Co-Administrator and Moderator
NHRA/IHRA/SRA member and licensed Superstock driver
MCA member# 53321
NHRA and IHRA SS/LA National Record Holder '00,'01,'02,&'03
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28
The Barry of BarrysGrrl
Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
Contact Us | Mustangsandmore Front Page
Copyright 2004, Steve LaRiviere. All Rights Reserved.
Ultimate Bulletin Board 5.47d