Brought to you in part by:
Topic: ARP rocker arm stud replacement
From: San Lorenzo, CA, USA
Registered: Aug 2001
posted 04-23-2003 05:09 PM
This weekend, i'm planning to swap my stock rocker arm studs for a set of PRO Series ARP rocker arm studs. I'll be using the red loc-tite on the threads. But should I need to clean the bolt holes in the head first? If so, what tool should I get to clean them? If I don't need to clean them, i'll just R&R them.
Thanks in advance.
1966 Ford Mustang 2+2
Mine - Restomod in Progress
1966 Ford Mustang Coupe
Dad's - Original Unrestored
From: Lyons, IL, USA
Registered: May 99
posted 04-23-2003 11:49 PM
A 7/16 thread chaser or tap will work fine.
Co-Administrator and Moderator
NHRA/IHRA/SRA member and licensed Superstock driver
MCA member# 53321
NHRA and IHRA SS/LA National Record Holder '00,'01,'02,&'03
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28
The Barry of BarrysGrrl
Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
Contact Us | Mustangsandmore Front Page
Copyright 2003, Steve LaRiviere. All Rights Reserved.
Ultimate Bulletin Board 5.47d