|
Author
|
Topic: what to do with wires for c-4
|
662+2
Gearhead Posts: 107
From: Ontario, Canada
Registered: Jan 2003
|
posted 04-23-2003 02:43 PM
   
I have changed from a standard to a automatic in my 66 mustang and the transmission I bought was out of a 69 and it has a plug hanging of it don't know what to do with it. I also have my back up switch left from the standard what should I do with this.
IP: Logged |
Moneymaker
Administrator Posts: 21725
From: Lyons, IL, USA
Registered: May 99
|
posted 04-23-2003 11:58 PM
It's the neutral saftey switch.
There should be a corresponding plug under the dash as part of the original factory harness that will plug in.------------------
Alex Denysenko
Co-Administrator and Moderator NHRA/IHRA/SRA member and licensed Superstock driver
MCA member# 53321
NHRA and IHRA SS/LA National Record Holder '00,'01,'02,&'03
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28
Professional Manwhore
The Barry of BarrysGrrl Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
www.moneymakerracing.com
IP: Logged |
662+2
Gearhead Posts: 107
From: Ontario, Canada
Registered: Jan 2003
|
posted 04-24-2003 07:07 AM
Thank you Alex but what about the back up light switch that is left do I just cut this off?
IP: Logged |
gregaust
Journeyman Posts: 22
From: australia
Registered: Jul 2002
|
posted 04-25-2003 04:25 AM
The wires from your original backup switch connect to 2 of the wires[black/red from memory] while the other 2 [red/blue] connect up to the start circuit..There is usually a plug in the harness which you disconnect,which opens up the start circuit ,then connect each side of this plug to the red/blue on the neutral start switch
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
