|
Author
|
Topic: Help build my Toploader set up
|
Skeeter
Gearhead Posts: 160
From: California
Registered: Dec 2001
|
posted 03-31-2003 02:15 PM
   
I have wide ratio Toploader and now just need the bellhousing, flywheel,clutch ect. This is for a 418w in a 67 Mustang. Its mainly a street car but will be at the track a couple times a year. I would like to know what has worked out best for all of you.
Thanks!
IP: Logged |
mustangboy
Gearhead Posts: 1098
From: Ont, Canada
Registered: Mar 2002
|
posted 03-31-2003 05:00 PM
Skeeter you might want to check out the rule book for whatever type of track you run,(IHRA or NHRA).That 418 might make you quick enough where you need a scattershield and a safety rated flywheel and clutch.I'd hate to see you buy all factory stuff and then go to the track and not be able to run it.Your going to need a pretty decent clutch if you've got traction.------------------
1968 mustang j-code sprint.13.69@101 306cu.in, stock ported heads,weiand exellerator,650 holley DP,hedman hedders,comp 292 Magnum cam,4-speed,8 inch 4.11 detroit locker http://mustangsandmore.50megs.com/MembersPics/mustangboy.html [This message has been edited by mustangboy (edited 03-31-2003).]
IP: Logged |
steve'66
Gearhead Posts: 9489
From: Sonoma,CA,USA
Registered: Mar 2000
|
posted 04-02-2003 10:27 PM
Yeah Skeeter,It's time for the good stuff, SFI approved.  SteveW
IP: Logged |
Skeeter
Gearhead Posts: 160
From: California
Registered: Dec 2001
|
posted 04-02-2003 11:16 PM
Hey Steve,
Where have you been hidding?Jason
IP: Logged |
Mustangsandmore Forums
