Brought to you in part by:
Topic: 351C piston and bearing advise?
Registered: Oct 2001
posted 03-06-2003 04:55 PM
I'm going to use Speed Pro + .030 hyper cast pistons in my 351C street machine. Any special advise on piston to wall clearance?
Also, my original main bearings were full grooved. Any thoughts on using full grooved versus half grooved bearings?
From: Lyons, IL, USA
Registered: May 99
posted 03-06-2003 06:21 PM
I like FG bearings with a HV Melling pump along with restrictors.
I always run cast pistons on the tighter side.
Co-Administrator and Moderator
NHRA/IHRA/SRA member and licensed Superstock driver
MCA member# 53321
NHRA and IHRA SS/LA National Record Holder '00,'01,'02,&'03
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28
The Barry of BarrysGrrl
Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
Contact Us | Mustangsandmore Front Page
Copyright 2003, Steve LaRiviere. All Rights Reserved.
Ultimate Bulletin Board 5.47d