|
Author
|
Topic: Building your own flow bench?
|
Snake_Eyes
Journeyman Posts: 59
From:
Registered: Nov 2002
|
posted 02-06-2003 07:35 AM
   
Does any one have any information on this? I think there was a magazine that had an article on it does any have or know what magazine it was?
Thanks
IP: Logged |
Mpcoluv
Gearhead Posts: 945
From: Charlotte NC usa
Registered: Apr 2001
|
posted 02-06-2003 07:57 AM
David Vizard had one from Audie Technologies (I think) to play with. If that is the one you are referring to, it test out with the same accuracy as a superflow 600. In fact Vizard really liked it. It's not in his shop now however.....The superflow still is.
IP: Logged |
Just Strokin
Gearhead Posts: 754
From: Tuscaloosa, Alabama
Registered: Dec 2001
|
posted 02-06-2003 08:22 AM
Popular Hot Rodding had an article on building a flow bench some years back. I think there is a guy on the net that has the article. You will have to do a search for it.Appears to have been CarCraft that did the article??? http://www.tractorsport.com//wwwboard.html
------------------
Larry No fast Fords at this time but one fine cruising 96 F350 CC DRW Power Strokin diesel.
And one rusty 64 Fairlane nick-named the Rust Bucket....And sometimes called the Money Pit... The sounds of a brain dropping into gear.....
"Buzzzzzz.......Click" [This message has been edited by Just Strokin (edited 02-06-2003).]
IP: Logged |
Snake_Eyes
Journeyman Posts: 59
From:
Registered: Nov 2002
|
posted 02-07-2003 07:01 AM
Found the articles I where looking for.Thanks
[This message has been edited by Snake_Eyes (edited 02-07-2003).]
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
