Brought to you in part by:
Topic: what would be envolved in
From: Manitoba Canada
Registered: Oct 2002
posted 12-05-2002 02:01 AM
making headers for a 351W that are designed for a c4 to fit a c6....could i bend them or something to fit?? nobody makes headers that will fit, other than shorty style.
1974 Gran Torino, 351W
1970 Mustang Grande, 289
Just a young buck
From: Lyons, IL, USA
Registered: May 99
posted 12-05-2002 06:31 AM
Almost ANY aftermarket 351W Torino header will fit a C-4 or C-6.
Co-Administrator and Moderator
NHRA/IHRA/SRA member and licensed Superstock driver
MCA member# 53321
NHRA and IHRA SS/LA National Record Holder '00, '01, & '02
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28
The Barry of BarrysGrrl
Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
[This message has been edited by Moneymaker (edited 12-05-2002).]
From: port alberni BC Canada
Registered: Apr 2002
posted 12-05-2002 09:20 PM
my headers are for a small block early 'stang in my fairlane,they fit just fine.stepped up(or is it down?)to a c-6 and no problems.mocking up my new 351 and still seems to be fine.I think any meant for your body style would probably be okay, as long as they dont specify auto or stick.
lots of fiberglass
even more bondo
Contact Us | Mustangsandmore Front Page
Copyright 2003, Steve LaRiviere. All Rights Reserved.
Ultimate Bulletin Board 5.47d