Brought to you in part by:
NOTICE! The old Mustangsandmore.com is a read-only archive.
Currently the Search function is inoperative, but we are working on the problem.
Please join us at our NEW Mustangsandmore.com forums located at this location.
Please notice this is a brand new message board, and you must re-register to gain access.
Topic: MSD crank trigger?
From: Gadsden, Al
Registered: Aug 99
posted 10-14-2002 04:01 PM
I have an MSD crank trigger for the BBF that I'm getting ready to go in my dragster.
There are little round dimples milled into the pickup bracket. I assume these are to allow a quick static timing adjustment. Does each one these dimples represent 1��or 2��timing?
From: Lyons, IL, USA
Registered: May 99
posted 10-14-2002 06:23 PM
Depends. Normally 2 degrees. I have seen them move as much as 5 depending on the box itself David.
Co-Administrator and Moderator
NHRA/IHRA/SRA member and licensed Superstock driver
MCA member# 53321
NHRA and IHRA SS/LA National Record Holder '00, '01, & '02
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28
The Barry of BarrysGrrl
Quote #1: "I never met a magazine mechanic I liked."
Quote #2: "Make sure brain is in gear before engaging mouth!"
Quote #3: "If you can't run with the big dogs, stay on the porch!"
Contact Us | Mustangsandmore Front Page
Copyright 2006, Steve LaRiviere. All Rights Reserved.
Ultimate Bulletin Board 5.47d