|
Author
|
Topic: Windsor SR heads anygood?
|
mustangboy
Gearhead Posts: 1147
From: Ont, Canada
Registered: Mar 2002
|
posted 08-31-2002 11:37 AM
  
Windsor SR heads fully ported and milled for 58cc combustion chambers.How much better are these than say fully ported 351 windsor heads with 194/160 valves.I know they don't flow as well as some of the new aluminum stuff but they're less than half price of any aluminum head I can get up here in Canada.
IP: Logged |
steve'66
Gearhead Posts: 9533
From: Sonoma,CA,USA
Registered: Mar 2000
|
posted 08-31-2002 03:08 PM
They sound like pretty good heads for the money. 
But it really depends on the quality of the porting. Do you have any flow numbers?SteveW
IP: Logged |
mustangboy
Gearhead Posts: 1147
From: Ont, Canada
Registered: Mar 2002
|
posted 08-31-2002 04:45 PM
No flow numbers, they're just in the classified adds,says they ran 10.50s on a DSS 357 motor.Doesn't say in what vehicle.
IP: Logged |
Dave_C
Gearhead Posts: 1069
From: Gadsden, Al
Registered: Aug 99
|
posted 08-31-2002 05:07 PM
I had those heads on the 383W in the 69 Mustang that I just sold. These heads were just home ported and were good enough for 6.80's 1/8 mile (10.70's 1/4) at 3000 lbs. I'm sure they could have done much more if pro-ported.If you can get them at a good price, go for it. Later, David Cole
IP: Logged |
the last dive
Gearhead Posts: 147
From: sydney australia
Registered: Dec 2001
|
posted 08-31-2002 08:35 PM
i have alloy windsor sr's they are ported,intake flow 298cfm @.600, 309 cfm @ .700lift,exh 201cfm @ .600,209 cfm @ .700,they are on my 347 ,i like them,go for it
IP: Logged |
Mustangsandmore Forums
