|
Author
|
Topic: Oil galley?
|
V8 Thumper
Gearhead Posts: 1470
From: Orange, Ca. United States of America
Registered: Dec 2001
|
posted 08-08-2002 11:31 PM
   
On the right bank, just behind the head on my '71 Mexican block, there's a 1/4" pipe female. Is that an oil galley tap? If so, being at the rear of the motor, would that be a good place to plumb my mechanical oil pressure fitting? [This message has been edited by V8 Thumper (edited 08-08-2002).]
IP: Logged |
Moneymaker
Administrator Posts: 13229
From: Lyons, IL, USA
Registered: May 99
|
posted 08-09-2002 07:23 AM
Use the drivers side 1/4 inch pipe hole above the oil filter.  ------------------
Alex Denysenko
Co-Administrator and Moderator/ non 65-66 Mustang owner sensitivity co-ordinator NHRA/IHRA/SRA member
NHRA and IHRA SS/LA National Record Holder '00, '01, & '02
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28
Part time secret agent license #0089
Professional Manwhore
The Barry of BarrysGrrl
IP: Logged |
V8 Thumper
Gearhead Posts: 1470
From: Orange, Ca. United States of America
Registered: Dec 2001
|
posted 08-09-2002 07:14 PM
Yup, that's where the stock elect. sender was ... was planning to keep the 5 gauge cluster functional (going to run SW mechanical oil & water gauges also), I suppose I could tee off for the mechanical gauge...Then what's the one on the right rear, as described above?  [This message has been edited by V8 Thumper (edited 08-09-2002).]
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
