|
Author
|
Topic: Victor Jr. Question
|
JAAZZY
Gearhead Posts: 918
From: Bay Area, CA
Registered: Apr 2001
|
posted 11-05-2001 02:44 PM
 
I installed a Victor Jr. intake on my 347 and I have a minor issue. This intake only has two threaded water inlets/outlets. I need one for the fuel injection and one for the temp gauge. This doesn't leave a place if I decide to put the heater hose back. Is there an easy solution? Thanks
|
TomP
Gearhead Posts: 6376
From: Delta BC Canada
Registered: Dec 99
|
posted 11-05-2001 03:31 PM
drill and tap another hole... there are bosses cast at the rear water passages aren't there? Heater will be less effective but makes the hose a bunch shorter.
|
JAAZZY
Gearhead Posts: 918
From: Bay Area, CA
Registered: Apr 2001
|
posted 11-05-2001 04:13 PM
Hey, that's not easy!  I was thinking that maybe there is a fitting that would allow two connections from one outlet, a modified T fitting.
|
Blu Dawg
Journeyman Posts: 60
From: Texas
Registered: Oct 2001
|
posted 11-06-2001 08:46 AM
On some newer modle GT's and such there are fittings that will take care of all your troubles. Just go to a junk yard and find what you need off an old intake.
|
JAAZZY
Gearhead Posts: 918
From: Bay Area, CA
Registered: Apr 2001
|
posted 11-06-2001 03:22 PM
Thx, I'll check it out.
quote:
Originally posted by Blu Dawg:
On some newer modle GT's and such there are fittings that will take care of all your troubles. Just go to a junk yard and find what you need off an old intake.
|
