|
Author
|
Topic: 31 spline axles
|
tomslo
Gearhead Posts: 318
From: Jefferson City, MO
Registered: Aug 2000
|
posted 06-06-2001 04:37 PM
   
Hello everyone! I finally got the Tomcat back and running, still breaking it in, though. It really really needs the lower gears. I am currently running a set of tree-fiddy's. I have a 4.11 Traction Lok pumpkin at home all ready to go, except that is a 31 spline unit. Soooo, I need to get some 31 spline axles. Which ones should I get? Strange, Moser, someone else? What kind of prices? I am planning on going with the 3 inch studs at this time as well. What else will I want to get with the new axles? What kind of info do I need for ordering, like length? Thanks for all the help!
Tom ------------------
1991 F150, 4X4, lift, 35's, 4.9l
1991 Mustang LX 5.0L, AOD
1970 Cougar, 351C-4v, C6
IP: Logged |
steve'66
Gearhead Posts: 6352
From: Sonoma,CA,USA
Registered: Mar 2000
|
posted 06-06-2001 04:56 PM
Tom,I use Moser, they are good axles and they have a 48 hour turn-around on custom axles. 3" studs are std. Paid about $320 (if I remember right for the last pair). Get their bearings and backing plates installed too. Here's a link to them, www.moserengineering.com SteveW [This message has been edited by steve'66 (edited 06-06-2001).] [This message has been edited by steve'66 (edited 06-06-2001).]
IP: Logged |
profalcon
Journeyman Posts: 30
From: Andrews AFB, MD
Registered: Feb 2001
|
posted 06-06-2001 05:42 PM
I use strange S/S axles on everything I build. My brother and father on the other hand use moser units. I don't think it would really make that big of difference. I looked at both when I bought the axles for my Falcon, and the only reason I bought the stranges was the wait time on the mosers was too long for the pieces I bought. ------------------
http://www.trawets.com
1999 F-150 4x4, 5" Superlift, 35" BFG M/T's, Precision Gear 4.56's
1961 2-dr Falcon -in work-
1954 F-100, 460, narrowed 9"
IP: Logged |
TomP
Gearhead Posts: 4780
From: Delta BC Canada
Registered: Dec 99
|
posted 06-08-2001 03:53 AM
if the rear end is stock width the factory 31 spline axles will do.
IP: Logged | |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
