Author
|
Topic: Welding a Roll Cage?
|
thumpin cat Gearhead Posts: 495 From: Santa Barbara, California Registered: Mar 2002
|
posted 04-03-2005 10:25 PM
Do you guys think my Hobart 135 amp 115 volt mig welder will be sufficient to weld .134 wall roll cage tubbing? (this welder is supposed to do 3/16 steel in one pass) What do you guys think?
IP: Logged |
Robert K Gearhead Posts: 705 From: Nashville, TN Registered: Apr 2000
|
posted 04-04-2005 07:54 AM
I'm not an expert but if it's anything like my Millermatic 130, then yes, no problem.
IP: Logged |
lonewolf Gearhead Posts: 308 From: Colorado; M&M #3117 Registered: Jul 2003
|
posted 04-04-2005 10:44 AM
I think NHRA mandates 100A on welding the cage with a MIG. No flux core or stick welding allowed. Since you can't grind the welds either, I would opt to have it TIG'd so it's pretty where the welds show.
IP: Logged |