|
Author
|
Topic: Welding question
|
SteveLaRiviere
Administrator Posts: 20669
From: Saco, Maine USA
Registered: May 99
|
posted 11-04-2000 01:49 PM
   
So not to damage my electrical system, how far away should I stay from any grounds to prevent feedback?Some of my welding will be on the firewall to attach the fender aprons, and I don't want to hurt anything. ------------------
SteveLaRiviere/Webmaster -- MCA # 47773
IP: Logged |
67stang
Gearhead Posts: 998
From:
Registered: Jun 99
|
posted 11-16-2000 10:54 PM
All I ever have been told was to disconnect the battery. Of course the heat will hurt electronics, but most of them can be moved temporarily out of the heat.The arc will go to ground and that will be through the ground clamp on the welder, so get it as close to where you are welding as practical.
IP: Logged |
SteveLaRiviere
Administrator Posts: 20669
From: Saco, Maine USA
Registered: May 99
|
posted 11-17-2000 05:03 PM
I'm concerned about backfeeding juice through the grounds.------------------
SteveLaRiviere/Webmaster -- MCA # 47773 Have rice for dinner, not transportation!
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
