Edelbrock Streetmaster 289 intake - Mustangsandmore Forums

Brought to you in part by:

Mustangsandmore Forums

Classified Ads -- No Commercial Ads Permitted

Edelbrock Streetmaster 289 intake

profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone!

next newest topic | next oldest topic

Author

Topic: Edelbrock Streetmaster 289 intake

hukares
Journeyman

Posts: 4
From: East Ohio
Registered: Nov 2003

posted 03-27-2004 10:18 AM

Can be seen in link below. Has damage but was removed from '70 fairlane 302 that ran perfectly and didn't leak. One carb flange hole is stripped out and two others should have helicoils installed also. As can be seen in pictures, the boss for the heater core connection was broken at one time and welded back up. As I said, it didn't leak, it just isn't pretty. Otherwise in good condition. Edelbrock no longer makes this intake but it is single plane with small runners and the height of the performer RPM. I imagine it to be comparable to a torker intake. The intake has been beadblasted since the pictures were taken. Asking $65 for the intake.
PIctures at: http://www2.admin-tech.net:3500/~davisb/parts.html
Thanks,
-Brian

[This message has been edited by hukares (edited 03-27-2004).]

IP: Logged

All times are ET (US)	next newest topic \| next oldest topic
Administrative Options: Close Topic \| Archive/Move \| Delete Topic
	Hop to:

Contact Us | Mustangsandmore Front Page

Ultimate Bulletin Board 5.47d

[Acronyms][Calendar][Chat][Classifieds] [Members' Pics]

[ Mustangsandmore.com Bookstore] [ Smokin' Fords] [Tech Articles]