|
Author
|
Topic: 67 Roller Idler Arm
|
joesgt350
Journeyman Posts: 2
From:
Registered: Nov 2005
|
posted 11-19-2005 10:54 PM
   
Anybody make one?Joe ------------------
click here for my site
IP: Logged |
Jake11
Gearhead Posts: 207
From: Banning,Ca,USA
Registered: Oct 2005
|
posted 11-20-2005 09:48 PM
I think "Maier" used to have them?
IP: Logged |
GregK
Gearhead Posts: 266
From: Clear Spring, Md
Registered: Mar 2004
|
posted 11-21-2005 07:41 PM
Youhttp://forums.vintage-mustang.com/forums/showflat.php?Cat=1&Number=1326493&an=0&page=0#1326493 may want to check this out.------------------
1968 coupe 351W, Bored.030,Stock Crank, Eagle I beam rods,Decked,KB Hyper. flat top pistons. Total Seal rings. Bullet Cam 231/[email protected]/.541 lift,AFR 185 Heads,RPM Air Gap,BG 750 Speed Demon,MSD Ignition,C4 Trans.,9" rear with 4.11 Detroit Locker, MT 275/60/15 Drag Radials (Engine dynoed at 420 hp/420 tq.)11.507 @ 116 mph in the 1/4 on 93 octane pump gas Thru Magna Flow Mufflers
IP: Logged |
Opentracker
Journeyman Posts: 7
From:
Registered: Oct 2005
|
posted 11-22-2005 12:17 AM
Yep - The Moog K8158 will work.
IP: Logged |
joesgt281
Journeyman Posts: 26
From: Katy, TX
Registered: Nov 2005
|
posted 11-23-2005 08:17 AM
quote:
Originally posted by GregK:
Youhttp://forums.vintage-mustang.com/forums/showflat.php?Cat=1&Number=1326493&an=0&page=0#1326493 may want to check this out.
Thanks Greg, that was my post as well, LOL
For some reason I had to log on here the other nite as joesgt350, my evil alter-ego! [This message has been edited by joesgt281 (edited 11-23-2005).]
IP: Logged |
Mustangsandmore Forums
