|
Author
|
Topic: Wiring harness routing
|
MidLifCrisis
Gearhead Posts: 464
From: Frederick County, MD
Registered: Oct 2001
|
posted 03-08-2005 10:21 PM
   
I am replacing the wiring harness in the engine compartment of my '67 convert. I can't remember if the wiring goes over the fuel line or runs under it on top of the frame rail. Can anyone help? Thanks, Charlie
IP: Logged |
vegas mach I
Journeyman Posts: 6
From: las vegas, nv usa
Registered: Mar 2005
|
posted 03-09-2005 01:38 AM
my 69 is above. I am pretty sure all of the 67's that I have seen had it above as well. I'll ask around.
IP: Logged |
MidLifCrisis
Gearhead Posts: 464
From: Frederick County, MD
Registered: Oct 2001
|
posted 03-09-2005 07:10 PM
Vegas Mach I Thanks, i was thinking it ran along the frame rail underneath the fuel line, but I unconsciously have it laying on top and I just don't remember. It's not a big issue, just one I want to get correct. Charlie
IP: Logged |
68 Coop
Gearhead Posts: 859
From: Mesquite, NV.
Registered: Oct 2004
|
posted 03-09-2005 07:26 PM
Charlie, are you talking about the dizzy wire cluster??? I have 3 seperate lines coming off the firewall and they all 3 are above the engine. 2 are over by the MC and they snake around to the VR via the shock tower. Hope it helps, but I'll check whatever I can for ya.  ------------------
William
68 Coupe
"Restomod in Progress"
IP: Logged |
MidLifCrisis
Gearhead Posts: 464
From: Frederick County, MD
Registered: Oct 2001
|
posted 03-10-2005 06:26 PM
quote:
Originally posted by 68 Coop:
Charlie, are you talking about the dizzy wire cluster??? I have 3 seperate lines coming off the firewall and they all 3 are above the engine. 2 are over by the MC and they snake around to the VR via the shock tower. Hope it helps, but I'll check whatever I can for ya.
I am talking about the harness that comes through the firewall in the big rubber grommet, goes past the master cylinder, around the drivers-side shock tower, through the radiator support, across the front and through the support again to plug into the alternator harness. It feeds all the front lights. Does this go along the frame rail below the fuel line or above? Thanks in advance for the help. Charlie
IP: Logged |
68 Coop
Gearhead Posts: 859
From: Mesquite, NV.
Registered: Oct 2004
|
posted 03-10-2005 06:45 PM
Above, about half way up the tower. You can almost draw a straight line from where it appears, to the front of the tower. They are held in place with plastic retainers that clip into the wall. It runs together with the rubber line from w/sheild bottle, in my case. That's what the 2nd line was that I saw. At the front of the tower, it dips down and goes where you said. Hope I am clear enough Charlie.------------------
William
68 Coupe
"Restomod in Progress" [This message has been edited by 68 Coop (edited 03-10-2005).]
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
