|
Author
|
Topic: Shelby Drop Template
|
My 66 coupe
Journeyman Posts: 45
From: Fort Bragg, NC
Registered: Feb 2004
|
posted 04-13-2004 07:20 PM
 
I have found a template on line but I can't get it to print to scale! I have tried all I know and it is really frustrating me  ! Has any one else ran into this problem? Any help would be great!
|
Mooney
Gearhead Posts: 2357
From: Marietta, Ga
Registered: Oct 2003
|
posted 04-13-2004 08:11 PM
I'd go into your printer settings and make sure your settings aren't set to "scale to fit". Not sure if it'd change anything either, but make sure the paper in the printer is the same size the options are set up for.
|
My 66 coupe
Journeyman Posts: 45
From: Fort Bragg, NC
Registered: Feb 2004
|
posted 04-13-2004 08:47 PM
Thank you but it didn't change anything  , any more ideas or any one have a template they can E-mail me that will print out to the right size without all the hassel  ?
|
hgufrin
Journeyman Posts: 78
From: Peoria, IL
Registered: Feb 2004
|
posted 04-14-2004 05:04 PM
My 66 coupe,What is your email address? I have a CAD drawing that might work for you... Yes, I had this problem too.
|
My 66 coupe
Journeyman Posts: 45
From: Fort Bragg, NC
Registered: Feb 2004
|
posted 04-15-2004 12:49 PM
[email protected] or [email protected] Thank you this is very helpful!
|
Tom G
Gearhead Posts: 1069
From: Bethlehem, Pa USA
Registered: Nov 2001
|
posted 04-15-2004 08:31 PM
Check out tony branda performance get his catalog there is a template include in the back of it. www.cobranda.com------------------
67 Mustang F/B 302 GT-40X FMS Crate engine RPM Air Gap 600 Holley Dynomax ceramic coated headers T5, cable clutch conversion Flowmasters X Pipe 3.89 equa loc 9". Clearwater Aqua GT Clone Vintage wheel works 16x8 40 series 225 front 255/50 rear drag radials 13.39 on 205/70/14 BFG @104 mph (New times when better weather gets here)!
|
