goldenbob Journeyman Posts: 86 From: medford, or., United States Registered: Jun 2002
|
posted 04-03-2004 04:20 PM
I'm ready to weld in some subframe connectors on a 67 coupe, but I'm not sure where the jack stands should be located to get the right geometry before I weld them in...any sugestions on this project?Thanks
IP: Logged |
Moneymaker Administrator Posts: 25539 From: Lyons, IL, USA Registered: May 99
|
posted 04-03-2004 05:04 PM
Middle of the front original sub frames and rear originals behind the rear end housing.------------------ Alex Denysenko Co-Administrator and Moderator NHRA/IHRA/SRA member and licensed Superstock driver MCA member# 53321 NHRA and IHRA SS/LA & SS/MA National Record Holder '00,'01,'02,'03,& '04 First SS/MA in the TENS! IHRA division 5 Superstock Champion Fleet of FoMoCo products including 88 ASC McLaren Mustang #28 The Barry of BarrysGrrl Quote #1: "I never met a magazine mechanic I liked." Quote #2: "Make sure brain is in gear before engaging mouth!" Quote #3: "If you can't run with the big dogs, stay on the porch!" www.moneymakerracing.com [This message has been edited by Moneymaker (edited 04-03-2004).]
IP: Logged |