Brought to you in part by:

.

JC Whitney clearance center!
  Mustangsandmore Forums
  '64 1/2 to '73 -- The Classic Mustang
  driveshafts

Post New Topic  Post A Reply
profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone! next newest topic | next oldest topic
Author Topic:   driveshafts
shoe
Gearhead

Posts: 228
From: midwest
Registered: Feb 2001

posted 01-18-2004 09:47 PM     Click Here to See the Profile for shoe   Click Here to Email shoe     Edit/Delete Message   Reply w/Quote
Any one tell me if a 68 Manual trans. 8" rearend, 302 driveshaft can be used on a 69 351W manual with a 9" rearend?

IP: Logged

Fastback68
Gearhead

Posts: 3053
From: Sucat, Paranaque, Philippines
Registered: Jul 99

posted 01-18-2004 09:51 PM     Click Here to See the Profile for Fastback68   Click Here to Email Fastback68     Edit/Delete Message   Reply w/Quote
Assuming the trannies are the same, the shaft will be too long for the 9-inch rear. Which is good. You can get it cut down to size.

IP: Logged

All times are ET (US)

next newest topic | next oldest topic

Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply
Hop to:

Contact Us | Mustangsandmore Front Page

Copyright 2005, Steve LaRiviere. All Rights Reserved.


Ultimate Bulletin Board 5.47d

Amazon Honor System Click Here to Pay Learn More

[Acronyms][Calendar][Chat][Classifieds] [Members' Pics]

[ Mustangsandmore.com Bookstore] [ Smokin' Fords] [Tech Articles]