|
Author
|
Topic: 69 Neutral Safety Switch
|
69 Sportsroof
Gearhead Posts: 1214
From: Valley, Alabama, USA
Registered: Mar 2002
|
posted 09-24-2003 10:15 PM
   
Is the switch located in the shifter housing or on the trans? The reason I ask is because I'm looking for an auto shifter and a guy has one but says the switch if for a c6. If it's in the shifter, what difference does it make? I'm assuming the same thing goes for the back up light switch as well.Thanks. ------------------
David G.
1969 Mustang Sportsroof
2003 Black Mustang Mach I
IP: Logged |
70SportsRoof
Gearhead Posts: 777
From: Phoenix, AZ
Registered: Dec 2001
|
posted 09-25-2003 12:13 AM
The FMX has it mounted on the shifter, under the shift indicator, and the C4 and C6 have it mounted on the trans itself, I believe (99% sure)------------------
Gary M.
1946 Ford pickup
1946 Ford pickup
1957 Ford FL 500 Twn Vic
1970 Mustang SportsRoof
IP: Logged |
69 Sportsroof
Gearhead Posts: 1214
From: Valley, Alabama, USA
Registered: Mar 2002
|
posted 09-25-2003 09:29 AM
Is the neutral safety switch and backup light switch the same thing or are there two different switches?If they are the same, will this switch connect to my existing wiring for the manual backup lights?
IP: Logged |
68 S-code GT
Gearhead Posts: 1129
From: Sayreville, NJ, US
Registered: Mar 2000
|
posted 10-04-2003 11:23 AM
I just found one in my garage yesterday along with the base plate that someone put in a 67 I once had. It look like the wires for the shift indicator light is cut because I guess the 67-68 runs down from the dash and under the carpet. I might also have the shifter lever part somewhere but I haven?t seen is yet. I think the lever is different because it looks like the lever actuates the safety switch. If you still need it give me about a week to see if I can find the lever. My time is very limited right now due to the new addition of a future Ford lover to our family. I think the backup switch is an integral part of the safety switch. It has a four pin plug with two male and two female ends on it and two red with blue stripe wires and two black with red stripe wires on it. [This message has been edited by 68 S-code GT (edited 10-04-2003).]
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
